Cleaning The Plinth Filter Flap; Cleaning The Tumble Dryer - Miele TXI 680 WP Operating Instructions Manual

Cleaning the plinth filter flap

 Use a damp cloth to remove any lint.
Make sure that you do not damage
the rubber seal when doing this.
 Close the heat exchanger flap.

Damage or ineffective drying if
drying takes place without a plinth
filter or when the heat exchanger flap
is open.
An excessive accumulation of lint
can damage the tumble dryer. If the
system is not leak-tight, this can
make the drying ineffective.
Only operate the tumble dryer with
the plinth filter installed and the heat
exchanger flap closed.
Cleaning and care

Cleaning the tumble dryer

Disconnect the tumble dryer from the
electrical supply.

Damage due to the use of
unsuitable care products.
Unsuitable care products could
damage plastic surfaces and other
parts.
Do not use any solvents, abrasive
cleaners, glass cleaners, or all-
purpose cleaners.
 Clean the tumble dryer and the seal
on the inside of the door with a
slightly damp soft cloth, a mild
solution of dish detergent, and water.
 Dry all the parts with a soft cloth.
55