Cleaning The Plinth Filter Flap; Cleaning The Dryer - Miele TWJ 660 WP Operating Instructions Manual

Cleaning the plinth filter flap

 Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
 Close the heat exchanger access
panel.

Damage or ineffective drying
when drying without a plinth filter or
with the heat exchanger flap open.
An excessive accumulation of fluff
can damage the dryer in the long
term. If the system is not leak-proof,
this can lead to ineffective drying.
Only operate the dryer with the plinth
filter fitted correctly and the heat
exchanger access panel closed.
Cleaning and care

Cleaning the dryer

Disconnect the dryer from the
electricity supply.

Damage due to the use of
unsuitable care products.
Unsuitable care products could
damage plastic surfaces and other
parts.
Do not use solvents, abrasive
cleaners, glass cleaners or all-
purpose cleaners.
 Clean the dryer and the seal on the
inside of the door only with a slightly
damp, soft cloth and mild detergent
or soapy water.
 Dry all parts with a soft cloth.
57