Starting Up The Server; Restarting The Server - Hologic Cenova Image Analytics Server 3.0 User Manual

Cenova Image Analytics Server 3.0 User Guide
Chapter 3: System Operation
5.
Note
Physical access to the server is required to restore power from a shutdown. If the server
is in a remote location, use Restart.
3.3.2

Starting Up the Server

If the server has been powered off, you can switch it back on by pressing the power
switch on the front of the computer. (An indicator light indicates whether the server is on
or off.) The Cenova software starts up automatically, and the server should be ready for
use within 3–5 minutes.
3.3.3

Restarting the Server

You might need to restart the Cenova server if results are not transferring. Often,
restarting the server clears any errors. In some cases, your service representative will ask
you to restart the server.
`To restart the server:
1.
2.
3.
4.
5.
Note
To continue using the server, refresh the browser by repeating steps 1–3.
Page 24
Click Shutdown. The server prompts 'Are you sure...?' Click OK to switch the
server off.
Using a computer that is on the same network as the Cenova server, open a web
browser.
Type the IP address for the Cenova server in the address box and press [Enter]. You
do not need to type 'http' or anything other than the IP address.
At the log-in screen, enter the user name ('Administrator') and password. The About
screen should appear as shown in the previous procedure.
On the About screen, click System Control.
From the System Control screen, click Restart. The server prompts 'Are you sure...?'
Click the Restart button once more. The server should shut down and then restart
automatically. The server should be ready for use within about 5 minutes.
MAN-05463-001 Revision 002