Harrod RUG-007 Instructions

Code:
No.2:RUG-007/011/053 No.3:RUG-008/009/054
Product:
No.2 and No.3 Steel Rugby Posts
No2 Steel Rugby Posts
1. 4 x FEP211 Hinge Assembly
2. 4 x FEQ664 Bottom Upright
2. 4 x RUG-105 Bottom Upright
3. 1 x RUG-101 Pair of Crossbars
4. 4 x RUG-107 Ground Socket
5. 4 x RUG-106 Top Upright
RUG-053 No2 Hinge Adaptor Only
1. 4 x FEP211 Hinge Assembly
5
2
1
4
Fig 1

Pack Contents:

(RUG-011 only)
(RUG-011)
(RUG-007)
View of Product
No2 Only
3
No3 Steel Rugby Posts
1. 4 x FEP223
2. 4 x FEQ666
2. 4 x RUG-100 Upright
3. 1 x RUG-101 Pair of Crossbars
4. 4 x RUG-102 Ground Socket
RUG-054 No3 Hinge Adaptor Only
1. 4 x FEP223
IMPORTANT: Please read the assembly instructions
carefully before starting to assemble you posts
Important Note for RUG-053 & RUG-054
If RUG-053 or RUG-054 have been purchased
for adapting an existing set of rugby posts, you
will need to cut down your existing uprights as
follows:
For sockets installed 25mm below ground level
the distance from the underside of the channel to
the bottom of the upright needs to be 2925mm.
For sockets flush with ground level this needs to
be 2900mm.

Safety Notes

1
A risk assessment must be carried out on the
erection of Hinged Rugby and RugbyAdaptors.
2
Always use mechanical assistance if the Risk
Assessment highlights this requirement.
3
Always check fasteners before use and tighten
where necessary.
4
Periodically apply grease to hinge fixing bolts to
pre-long the life the posts.
5
Posts should always be taken down if strong
winds are forecast.
6
Post Protectors must be used with all Hinged
Rugby Posts to cover the hinge arrangement.
© Harrod UK Limited
(RUG-009 only)
Hinge Assembly
(RUG-009)
Upright
(RUG-008)
Hinge Assembly

Tools Required

1 x 22mm Spanner
2 x 19mm Spanners
2 x 17mm Spanners
1 x Spirit Level
1 x Tape Measure
2 x Step Ladders
INS631
Revision 5
08/09/2015