Summary of Contents for Ashford RIGID HEDDLE FREEDOM ROLLER
Page 1
Ashford Guarantee 415 West Street, Ashburton 7700, New Zealand Thank you for purchasing this Ashford product. In the unlikely event there is Telephone 64 3 308 9087 any fault in manufacture, please contact the dealer you purchased it from. To sales@ashford.co.nz www.ashford.co.nz...
Page 2
ASSEMBLY INSTRUCTIONS FOR THE ASHFORD RIGID HEDDLE FREEDOM ROLLER Before commencing: Please read the instructions For older models: If your Rigid Heddle Loom does completely, identify the parts and note the not have holes in the sides, mark the holes as assembly sequence.
Page 3
Rub candle wax onto the thread of the 30mm (1 ¼") bolt. Then attach the pawl to the roller support from the inside with this bolt. NOTE the clicker pin fits into the gap in the pawl. Take care to ensure the “clicker pin”...
Page 4
Place the cog onto the end of the roller. Check the teeth engage the pawl. THEN secure with a washer and 25mm (1") screw. Locate the 4 pins on the handle into the 4 holes in the cog. Then give the handle a sharp hit with your fist so it snaps down tight onto the cog.
Page 5
Attach the 2 steel brackets to the roller supports with 16mm (5/8") screws. Connect the warp stick to the roller with warp stick ties. First push the arrow head through the warp stick. Then push the arrow head into the small hole in the roller and out the large hole as illustrated.
Page 6
Freedom Roller. For warping instructions, please see our Learn to weave on the Rigid Heddle booklet or video on our web site. Ashford Handicrafts Limited 415 West Street, Ashburton 7700, New Zealand Telephone 64 3 308 9087 sales@ashford.co.nz www.ashford.co.nz...
Need help?
Do you have a question about the RIGID HEDDLE FREEDOM ROLLER and is the answer not in the manual?
Questions and answers