Page 1
Side Frame (2) Divided Tub (1) Large Pocket (2) Small Pocket (8) Big Book Rack (1) Open Tub (1) Casters (4) Small Tub (2) Please Recycle Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 2
Tabletop Easel Pocket Chart Small Tub Caster Large Pocket Open Tub Shelf Small Pocket Wire Shelf Divided Tub Big Book Rack Additional tools required: Adjustable wrench Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 3
Clean the Whiteboard surface well with soapy water and then rinse clean; or clean the board well with Soy Safe (Copernicus Product #AC405) We recommend expo brand markers for all our whiteboards. Be sure to replace your markers when needed. Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 4
Ensure that both short sides of the Stretchers are on the same side Note stretcher orientation Note labeling on Middle Frame, ensure it is installed correctly Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 5
- Bolts fit through top corner grommets in Pocket Chart - Fasten with 2 M6 40mm Bolts & Lock Washers - Hand tighten only Repeat for other side Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 6
- Fasten with 6 M6 40mm Bolts & Lock Washers - Hand tighten only Ensure that both short sides of the Stretchers are on the same side Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 7
Attach Wire Shelf Place the Wire Shelf over the Assembled unit - Fasten with 2 M6 30mm Bolts, Lock Washers & Nuts - Hand tighten only Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 8
Tighten all fasteners on the unit (18 in total) - Ensure that the unit is square, and level - If not, check your steps, and make sure bolts are tight enough Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 9
Align the wire racking with the holes in the Assembled unit - Fasten with 4 M6 30mm Bolts, Lock Washers & Nuts - Tighten bolts Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 10
(Not to Scale) Caster x 4 Attach Casters Push casters into the legs of the unit - Casters will snap into place and should be secure Push Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 11
Place Easel onto the assembled unit - The 4 rubber feet on the Easel register into holes in the Top Shelf - Ensure that the unit is secure Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 12
You will need: (Not to Scale) Small Tub x 2 Divided Tub x 1 Open Tub x 1 Insert Tubs Slide Tubs into Frame Channels Slide Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Page 13
Copernicus Product #AC 405 The beautiful thing about learning is that no one can take it away from you. “ ” - B. B. King Premium Model CC3- Version E - Released 24 October 2008 - Copernicus Educational Products Inc.
Need help?
Do you have a question about the CC3-2008-E and is the answer not in the manual?
Questions and answers