Table of Contents
Advertisement
"MODE "
to move the cursor to the bottom, and select "ok" to complete
the creation of a new document or select "cancel" to exit.
8.2
Verifying and saving by point
After selecting a verified data document, the interface displayed is
as follows:
You can see in the interface how many pressure points have been
selected when creating the document. Use the keys of
select different pressure points for checking. Press
the cursor to the bottom, and select "edit" to modify the parameters of
the current document, and select "start" to start verification and
recording.
When the verification and recording is started, the interface
switches to the routine measurement interface (current, voltage or switch)
corresponding to the type of sensor to be recorded in the document.
"Verified data recording identification" will appear on the upper part of
the interface, as shown in the circle below:
15
" ↑ "" ↓ "
"MODE "
to move
to
Advertisement
Table of Contents
