Table of Contents
Advertisement
Replacing guiding roll / carbide inserts
Before replacing the machine must be
disconnected from the compressed air
supply and secured against reconnec-
tion.
1
Lock spindle !
2
Loosen the guiding roll with Torx wrench T15 and
pull out the guide wheel of the milling head.
Then loosen the clamping screws with the Torx
3
wrench T15 and replace the carbide inserts. The
inserts must be fastened to the mounting seat on
the milling head by means of the original locking
screws (max. tightening torque: 4.0–5.0 Nm).
In order to avoid cuts and burns when
carbide inserts change, carbide inserts
only change to a complete stop of the
machine. Use protective gloves!
©
Adjusting the 4-fold insert type MV and the 8 bevel
and radius inserts (type SX and RSX):
The bevel and radius carbide inserts of type SX and RSX
each have 8 cutting edges. By turning and turning, it is
possible to use the cutting edges 8 times and the radius
carbide insert up to 16 times.
The MV carbide insert has 4 cutting edges each. By turn-
ing and turning, it is possible to use the indexable inserts
four times.
Consumables and accessories
nr.
name of part
Clamping screw
1
CS-30-09
Bevel-carbide insert
2
MV4.B12-V1
Bevel-carbide insert
3
SX8.B22-V1
Radius-carbide insert
4
R1.2-SX16.B22-V1
Radius-carbide insert
5
R2.5-SX8.B22-V1
Guiding roll (MV)
6
GR45.M3-SD2.V1
Guiding roll (SX)
7
GR45.S3-SD1.V1
Guiding roll (R1.2)
8
GR45R1.2.S3-LC2.V1
Guiding roll (R1.2)
9
GR45R1.2.S3-SC2.V1
Guiding roll (R2.5)
10
GR45R2.5.S3-SC2.V1
Torx-wrench
11
T15
Screwdriver
12
SW4
milling bodies with special angles and radii
on request
Settings
order-nr.
0101.203.16-00001
0101.404.19-00058
0101.404.19-00075
0101.404.19-00063
0101.404.19-00076
0101.113.19-00003
0101.113.19-00002
0101.113.19-00004
0101.113.19-00005
0101.113.19-00006
0000.077.14-00001
0000.077.15-00014
15
Advertisement
Table of Contents
