Table of Contents
Advertisement
CHECKING FOR BLOCKAGES
CHECK HANDHELD
Remove the handheld vacuum from the wand and
check all dust cup intake openings.
CHECK FLOOR NOZZLE
Detach the wand, then remove the Soft Roller.
Tilt the floor nozzle tube back and check openings for
blockages. Reinsert Soft Roller until it clicks securely
into place.
Remove any blockages or debris from the floor nozzle
debris intake (See Nozzle Maintenance section).
10
AUS 02 8801 7666 NZ 0800 112 660
MAINTENANCE
CHECK WAND
Detach the wand and check it for blockages.
NOZZLE MAINTENANCE
CLEANING THE SOFT ROLLER
1
To remove the Soft Roller, slide the Eject Roller
button on the floor nozzle.
2
Tap loose debris off the Soft Roller. Use a dry
towel to wipe it clean, and to remove any debris
caught in the teeth behind the Soft Roller.
3
Hand-wash the Soft Roller as needed. Use only
water, and let it air-dry completely for at least
24 hours.
4
Reinsert the Soft Roller and press it in until it clicks
securely into place.
NOTE: For best performance, keep the Soft Roller clean with regular maintenance.
AU S s h a r kc l e a n . c o m . a u
MAINTENANCE
If you notice any hair wrap, continue
vacuuming and the Self-Cleaning Brushroll
will automatically remove it. If some hair
wrap remains after continued use, remove
the brushroll cover from the bottom of the
nozzle and use scissors to carefully cut away
the hair.
To remove the cover, use a coin to turn the
locks counterclockwise. Lift off the cover
and remove any debris or hair wrap. Check
the Debris Intake and clear away any dirt or
blockages.
To close the cover, push down until it clicks
into place, then turn the locks clockwise
until closed.
N Z s h a r kc l e a n . c o . n z
11
Advertisement
Table of Contents
