During Operation; Starting The Machine; Using The Self-Propel Drive; Adjusting The Blade Speed - Toro 21852 Manual

During Operation

Starting the Machine

1. Ensure that the battery pack is charged and installed in the machine; refer to
(page 11).
2. Insert the electric-start button into the electric starter switch (A of
3. Squeeze the blade-control bar and hold it to the handle (B of
4. Press the electric-start button and keep it pressed until the motor starts (C of

Using the Self-Propel Drive

•
To engage the self-propel drive, pull the
self-propel-drive bar to the handle and hold it
(Figure 11).
•
To disengage the self-propel-drive, release the
self-propel drive bar.
Note:
To reduce the ground speed, increase the
space between the self-propel drive bar and the
handle.
1. Self-propel-drive bar
Figure 11
Figure
Figure
Figure 10

Adjusting the Blade Speed

This machine has 2 blade-speed settings: A
M .
AX
•
When set to the A
is adjusted automatically for greater efficiency;
changes in cutting conditions are detected and
the blade speed increases when necessary to
maintain quality of cut.
•
When set to the M
remains at the highest speed at all times.
Turn the key in the key switch to either position to
adjust the blade speed setting
g240765
1. A position
UTO
13
Installing the Battery Pack
10).
10).
Figure 10).
position, the blade speed
UTO
position, the blade speed
AX
(Figure 12).
Figure 12
2. M position
AX
g332149
and
UTO
g337279