During Operation; During Operation Safety - Toro 74667 Operator's Manual

Figure 18
1. Bolt (5/16 x 3/4 inch)
2. Cutoff baffle
10. Torque the fasteners to 7 to 9 N∙m (14 to 18
ft-lb).
11. Lower the grass deflector over the discharge
opening.
Important:
Ensure that the mower has
a hinged grass deflector that disperses
clippings to the side and down toward the
turf while in side-discharge mode.
Installing the Right Baffle for Mulching
1. Park the machine on a level surface, disengage
the blade-control switch, and engage the parking
brake.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the cutoff baffle from the mower deck
(Figure 18).
4. Remove the right mower blade; refer to
Removing the Blades (page
5. Slide the right baffle under the mower deck, and
secure it using 2 knobs and the curved washers
(cupped side facing the mower) as shown in
Figure 16 and Figure
Important:
Ensure that the tab on the far
right side of the right baffle is outside of the
mower and is flush with the mower wall.
6. Install the right mower blade; refer to
the Blades (page
3. Locknut (5/16 inch)
50).
17.
Installing
51).

During Operation

During Operation Safety

General Safety
•
The owner/operator can prevent and is responsible
for accidents that may cause personal injury or
property damage.
•
Wear appropriate clothing, including eye
g015321
protection; long pants; slip-resistant, substantial
footwear; and hearing protection. Tie back long
hair and do not wear jewelry.
•
Do not operate the machine while ill, tired, or
under the influence of alcohol or drugs.
•
Never carry passengers on the machine and keep
bystanders and pets away from the machine
during operation.
•
Operate the machine only in good visibility to avoid
holes or hidden hazards.
•
Avoid mowing on wet grass. Reduced traction
could cause the machine to slide.
•
Ensure that all drives are in neutral, the parking
brake is engaged, and you are in the operating
position before you start the engine.
•
Keep your hands and feet away from the cutting
units. Keep clear of the discharge opening at all
times.
•
Look behind and down before backing up to be
sure of a clear path.
•
Use care when approaching blind corners, shrubs,
trees, or other objects that may obscure your
vision.
•
Do not mow near drop-offs, ditches, or
embankments. The machine could suddenly roll
over if a wheel goes over the edge or if the edge
gives way.
•
Stop the blades whenever you are not mowing.
•
Stop the machine and inspect the blades after
striking an object or if there is an abnormal
vibration in the machine. Make all necessary
repairs before resuming operation.
•
Slow down and use caution when making turns
and crossing roads and sidewalks with the
machine. Always yield the right-of-way.
•
Disengage the drive to the cutting unit and shut
off the engine before adjusting the height of
cut (unless you can adjust it from the operating
position).
•
Never run an engine in an area where exhaust
gases are enclosed.
•
Never leave a running machine unattended.
22