Transportation And Installation; Safety Precautions - Scandomestic Scancool SD 46 E User Manual

TRANSPORTATION AND
INSTALLATION
Place on level floor and remove the bottom
packing, in order to decrease the shock and
noise.
The angle between the compartment body
and ground should be no more than 45°
Enough space should be left between the
freeze and the wall for ventilation.
Place the freezer away from heat source
and do not expose to direct sunshine.
Do not install where there is moisture or
where it can easily be splashed by water.
Do not place the freezer in environment
prone to freezing.
The appliance should not be used in open
air and should not be exposed to rain.
ADJUSTMENT AND
RUNNING
Adjustment of temperature: The storing
temperature can be adjusted by the ther-
mostat of the compartment. The ther-
mostat should be adjusted according to
different environment temperature and
the food by rotating the knob of the ther-
mostat. The knob rotates clockwise from
"1" to "7" (or direction arc) and the inside
temperature turns down in summer (anti-
clockwise rotation) and up in winter
(clockwise rotation). It is usually fixed to a
certain point before leaving the factory. Do
not adjust too often or touch the other
parts.
Trial running: plug in and wait. The marked
drop in temperature within half an hour
indicates that the freezer works properly.
The compressor should be left to run for a
period of time (6 hours in summer 4 hours
in winter) before putting the food in.

SAFETY PRECAUTIONS

The freezer should use a single 3-pin socket
with (13A) fuse. A multi –plug outlet should
not be used.
You should install a suitable automatic
voltage regulator not less than 500w when
the voltage is outside the range from 187V
to 242V.
The sockets of the freezer should be con-
nected to stable fixed connection. Under no
circumstance should the wiring be connect-
ed to such facilities as water pipe, gas pipe
and so on.
Once power is cut off, wait for at least 5
minutes before plugging in again to avoid
damaging the compressor or the system.
Do not put combustible, explosive or vola-
tile dangerous articles, heavily corrosive
acid or alkali of liquid in glassware into the
freezer.
Children should be kept away from the
freezer to avoid da- mage to the inner con-
tainer or any accidents being incurred
If the power cable damages, for avoid dan-
gerous, must by manufactory or its maintain
a set or similar profession job the personnel
replaces.
FREEZING METHODS
Do not put too much food into the freezer
or exceed the loading line.
Proper space should be allowed between
foods to ensure cooling air circulation.
Never use corrosive detergent, hot water,
or washing power to clean the freezer.
Do not use water to scour the freezer. Do
not use hard brushes or wire brushes to
clean the freezer.
Do not use metal or sharp tools for defrost-
ing.
Do not use electric heaters to heat up and
defrost.
The green lamp is a power indicating lamp.
When the power is on, the lamp will be on.