Miele HR 1934-3 DF Operating Instructions Manual page 118

Frequently Asked Questions
Problem

Fault F32 appears on
the display.

Fault F33 appears on
the display.
Fault and a fault code
not listed here appear
on the display.
No signal to the probe. Re-
position the probe in the
appears on the
oven.
display.
Fault with moisture control -
the automatic programs will
operate without moisture
appears on the display
after you have selected
a automatic program.
You can hear a noise af-
ter a cooking program.
118
Possible cause and solution
The door lock for the Self Clean program has not
locked.
 Turn the oven off and then back on again. Start the
Self Clean program again.
 If the message appears again, contact Miele
Customer Service.
The door lock for the Self Clean program has not
opened.
 Turn the oven off and then back on again.
 If the door lock still does not deactivate itself,
contact Miele Customer Service.
A fault has occurred that you cannot resolve.
 Contact Miele Customer Service.
The probe is not being recognized.
 Reposition the probe in the food.
If the probe is still not being recognized, the signal
has failed due to another cause.
In some cases, reception interference can even be
caused by a microwave operating in the vicinity of
the oven, because the microwave uses a similar
frequency range to that of the wireless probe.
 Turn off the microwave when you are using the
wireless probe.
If the probe is still not being recognized, it is faulty.
You can purchase a new probe from your Miele
dealer or from Miele Customer Service.
The steam injection system is faulty.
 Contact Miele Customer Service.
Automatic programs can be run without using
moisture injection.
The cooling fan remains turned on after a cooking
program (see "Settings – Cooling fan run-on").