Zumtobel DIMLITE Product Handbook page 10

ON/OFF
only
no
OFF
funct.
ON/corr
Mode
ON/OFF
no only
OFF
funct.
ON/corr
Mode
min
0
0,5
60
1
45
30 5
20 10
15
Run-On
Note:
! If at least one ED-SENS multi-sensor is connected to the universal, digital ContrIN interface, the
PD/T input is not active
! All presence detectors/motion sensors connected to the PD/T input or the universal, digital Contr�IN interface use
the settings (Mode, Run-On) made on the DIMLITE control device�
! The presence detectors connected to the universal digital Contr�IN interface can be assigned to individual
luminaire groups (see the section "Assigning an ED-SENS multi-sensor to one or more luminaire groups",
page 31)�
! If no ED-SENS multi-sensor is connected to the universal digital Contr�IN interface, and no motion sensor for
presence-linked control or no momentary-action switch for stairwell function is connected to the PD/T input, the
rotary selector switch mode must be set to "no funct�"
6 DIMLITE Installation and commissioning manual 4.0 | 01.2014 | en
D E S C R I P T I O N O F F U N C T I O N S
Mode ON/corr (recall lighting scene and change to corridor
lighting scene)
A lighting scene is recalled when a person enters the detection range
of the presence detector� If no one is located in the detection range, a
corridor lighting scene is recalled once the run-on time has expired� The
brightness for the corridor lighting scene is fixed at 10% (for all luminaire
groups)�
If multiple presence detectors are used: The corridor lighting scene is only
recalled once all presence detectors register that the area is empty, and
the last run-on time has expired and the fade time has passed�
Mode no funct
Presence-linked control is not operational�
Run-On
Run-on time for the modes ON/OFF, only OFF und ON/corr Available
settings: 0 min, 0�5 min, 1 min, 5 min, 10 min, 15 min, 20 min, 30 min,
45 min and 60 min�