Table of Contents
Advertisement
THE AFR SLR-40 COMES PRE-WIRED WITH THE SOLAR PANEL ATTACHED. THE FAN WILL TURN ON
AUTOMATICALLY WHENEVER THE SUN SHINES ON THE SOLAR PANEL.
DO NOT REMOVE PAPER COVER THAT IS LOCATED ON THE SOLAR PANEL UNTIL THE INSTALLATION IS
FINISHED. REMOVAL OF THE COVER CAN CAUSE UNINTENDED INJURIES IF THE FAN TURNS ON DURING
2.3 INSTALLING AFR SLR MODEL
1. Determine in which area you would like to install your QuietCool Attic Roof Mount Fan.
IMPORTANT:
After choosing the location where your roof mount attic fan will be installed, find the
!
!
closest rafter to that location and determine if your roof has either 16" on center or 24" on center rafter
spacing.
2. Find the center point between the two rafters and mark it as the center of the vent hole. Partially insert a
screw into the center point mark.
NOTE:
If you have a tile roof, you will need to move the tiles out of the way before tracing and cutting.
! !
(See Figure 2.3A)
3. Go to the roof. Using the screw as a reference point, trace out a 14" diameter circle using the provided
template.
Figure 2.3A
Figure 2.3E
8
CAUTION
INSTALLATION.
Figure 2.3B
Figure 2.3F
Installation Video:
Watch the video by scanning the QR
www.QuietCoolSystems.com/support
Figure 2.3C
Figure 2.3G
code or visit
Figure 2.3D
Figure 2.3H
1-888-QUIETCOOL
Advertisement
Table of Contents
