Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Analytic Systems PWS610 Series
Summary of Contents for Analytic Systems PWS610 Series
- Page 1 PWS610 Series Power Supply Installation & Operation Manual...
- Page 2 Improper connection can result in a risk of an electric shock. Analytic Systems does not recommend the use of the PWS610 Series Power Supplies in life support applications where failure or malfunction of this product can be reasonably expected to cause failure of the life support device or to significantly affect its safety or effectiveness.
- Page 3 Fastenings 18-8 Stainless Weight 7.2 lb / 3.3 kg designed and manufactured by: ANALYTIC SYSTEMS WARE (1993) LTD. #207 12448 82 Ave. Surrey, B.C., V3W 3E9, Canada phone (604) 543-7378 fax (604) 543-7354 toll free 800-668-3884 US/Canada email: info@analyticsystems.com; web site: www.analyticsystems.com Rev.
- Page 4 INSTALLATION MOUNTING Mount the unit in a DRY location. Allow at least 4 inches of clearance around it for adequate cooling. POWER CONNECTION The unit is supplied with a 5 foot power cable. This should normally be adequate to connect to a source of power.
- Page 5 the case, you can increase the output voltage of the unit that is reading low using the output adjust potentiometer. OPERATION Turn the switch on the top of the unit on to energize the outputs. The green ‘Output On’ indicator light will glow to indicate the proper operation of the unit.
- Page 6 Dry Contact Relay To use your dry contact output fail relay you must connect a 9-pin D connector to the unit. You must use pins one and six as is indicated on page 6 in the remote connector diagram. The relay is factory preset to fail in the closed position when the low output LED and buzzer come on.
- Page 7 REMOTE CONNECTOR This connector is located on the side of the unit. Note: All switches are electronic (solid state) not mechanical relays. REMOTE CONTROL A remote control panel may be connected to the power supply using a 9-pin D-connector that attaches to the side of the power supply. The remote control panel and D connector are part of the remote control option.
- Page 8 Limited Warranty The equipment manufactured by Analytic Systems Ware (1993) Ltd. (the “Warrantor”) is warranted to be free from defects in workmanship and materials under normal use and service. This warranty is in effect for 3 years from the date of purchase by the user (the “Purchaser”).
Need help?
Do you have a question about the PWS610 Series and is the answer not in the manual?
Questions and answers