modway EEI -2776 Quick Start Manual

Download this manual

EEI –2776

CHAIR

Thank you for purchasing the MODWAY CHAIR！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a

carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all fitting out of reach of children.

Components:

Chair Body

Customer Service 908-368-1025︱www.modwayfurniture.com

Hardware:

Chair Leg

Phillips Head Screwdriver

Bolt M8 x35mm

Flat Washer M8

Screw M4x25mm

Allen Wrench M5

( Not included)

Back Cushion

Page 1 of 2

Need help?

Do you have a question about the EEI -2776 and is the answer not in the manual?

Page 1 EEI –2776 CHAIR Thank you for purchasing the MODWAY CHAIR！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI –2776 CHAIR STEP 1: Put Chair Body (1) upside down on a carpeted or padded surface. Place 1 piece of Chair Leg (2) to the bottom of Chair Body (1) as shown. Insert 2 pieces of Bolts (A) with 2 pieces of Flat Washers (B) into the pre-drilled holes on Chair Body (1) through the pre-drilled holes on Chair Leg (2).