Advertisement
Table of Contents
EEI-4368/EEI-4369/EEI-4370/EEI-4371/EEI-4372 OFFICE CHAIR
Thank you for purchasing the MODWAY OFFICE CHAIR!
Before you start, here are some helpful advice:
1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step
instructions.
2. Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3. Please do not use any tools other than those provided or recommended in these instructions.
4. Please do not throw away any of the packaging or the instruction until you have checked all the components
and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe
and environmentally friendly way.
5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten
the components from time to time, so please save the tools that have been provided.
6. Please keep all pieces out of reach of children.
EEI-4368 / EEI-4369 / EEI-4370
Components:
1. Base
x1
4. Cylinder Column
Customer Service 609-256-9000︱www. modway.com
2. Castor
x1
EEI-4371 / EEI-4372
x5
5. Body with Control Mechanism
3. Plastic Cap
x2
x1
Page 1 of 3
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for modway EEI-4368
Summary of Contents for modway EEI-4368
- Page 1 EEI-4368/EEI-4369/EEI-4370/EEI-4371/EEI-4372 OFFICE CHAIR Thank you for purchasing the MODWAY OFFICE CHAIR! Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2. Owing to the size and weight of the office chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
- Page 2 EEI-4368/EEI-4369/EEI-4370/EEI-4371/EEI-4372 OFFICE CHAIR STEP 1: 1. Please put Base (1) on a carpeted or padded surface. 2. Insert 1 piece of Castor (2) into the Base (1) as shown by hand. 3. Repeat the same steps for the remaining 4 pieces of Castors (2).
- Page 3 EEI-4368/EEI-4369/EEI-4370/EEI-4371/EEI-4372 OFFICE CHAIR STEP 3: Body with Control Mechanism (5) into the Cylinder Column (4) as shown. Insert the Attention: When you use the handle to adjust the height to be lower, please move away your feet from the base at the same time.
Need help?
Do you have a question about the EEI-4368 and is the answer not in the manual?
Questions and answers