Operation - Bosch AL 2204 CV Original Instructions

OBJ_BUCH-1153-005.book Page 4 Wednesday, November 16, 2016 7:21 AM
4 | English

Operation

Starting Operation
 Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
Charging Procedure
The charging procedure starts as soon as the mains plug of
the battery charger is inserted into the socket and the battery
1 or the power tool with the slid on battery 1 is inserted on the
battery charger. The power tool cannot be switched on during
charging.
Firstly, place the battery 1 as shown in the figure onto the
front of the battery charger () and then press the battery 1
down at the rear (). To remove the battery, proceed in re-
verse order.
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery is
charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see Section "Technical Data".
Meaning of the Indication Elements
Flashing Battery Charge Indicator 2
The charging procedure is signalled by a
flashing battery charge indicator 2.
Continuous Lighting of the Battery Charge Indicator 2
Continuous lighting of the battery
charge indicator 2 indicates that the
battery is fully charged or that the
temperature of the battery is not with-
in the allowable charging temperature range, and cannot be
charged for this reason. The battery is charged as soon as the
allowable charging temperature range is reached.
When the battery is not inserted, continuous lighting of the
battery charge indicator 2 indicates that the mains plug is in-
serted in the socket and that the battery charger is ready for
operation.
1 609 92A 3NP | (16.11.16)
Troubleshooting Causes and Corrective
–
Measures
Cause Corrective Measure
Continuous lighting of the battery charge indicator 2
No charging procedure possible
Battery not (properly) inserted Properly insert battery
into battery charger
Battery contacts contaminated Clean the battery con-
tacts (e.g. by inserting
and removing the battery
several times) or replace
the battery
Battery pack defective Replace the battery
Battery charge indicator 2 does not light up
Mains plug of battery charger Insert mains plug (fully)
not plugged in (properly) into the socket outlet
Socket outlet, mains cable or Check the mains voltage;
battery charger defective have the battery charger
checked by an authorised
after-sales service agent
for Bosch power tools
Working Advice
With continuous or several repetitive charging cycles without
interruption, the charger can warm up. This is not meaningful
and does not indicate a technical defect of the battery charg-
er.
A significantly reduced working period after charging indi-
cates that the battery is used and must be replaced.
Maintenance and Service
After-sales Service and Application Service
Our after-sales service responds to your questions concern-
ing maintenance and repair of your product as well as spare
parts. Exploded views and information on spare parts can al-
so be found under:
www.bosch-pt.com
Bosch's application service team will gladly answer questions
concerning our products and their accessories.
In all correspondence and spare parts orders, please always
include the 10-digit article number on the type plate of the
battery charger.
Great Britain
Robert Bosch Ltd. (B.S.C.)
P.O. Box 98
Broadwater Park
North Orbital Road
Denham
Uxbridge
UB 9 5HJ
Tel. Service: (0844) 7360109
Fax: (0844) 7360146
E-Mail: boschservicecentre@bosch.com
Bosch Power Tools