Table of Contents
Advertisement
Hardware Installation
2.3.3 Fan
Plug in the fan cable to the fan connectors onboard. The fan connectors are
marked FAN1, FAN2 and FAN3 on the system board. You can plug the CPU
fan cable to both the 2-pin fan connector FAN1 and the 3-pin fan connector
FAN2. FAN3 can be reserved for the housing fan. Note that only FAN2
supports the fan monitoring function, because 3-pin fan has an extra pin
called SENSE, which periotically sends fan signal out.
2.3.4 PS/2 Mouse
The onboard PS/2 mouse connector is a 6-pin Mini-Din connector marked PS2
MS. The view angle of drawing shown here is from back panel of the housing.
2-14
SENSE
GND
FAN2 & FAN3
FAN1
PS/2 Mouse
+12V
GND
+12V
PCB
Advertisement
Table of Contents
