Advertisement
Tip: If the Display Does Not Scroll As Expected
When power is first applied, the unit should quickly go through its startup
routine and begin cycling through the pre-programmed display items. If
the display does not scroll after startup and/or looks similar to the
following: (Part numbers are for example only)
Disconnect the main power and then re-connect it. You should see
something similar to:
Verifying Flash
XXXXX
Checksum = Passed
XXXX = XXXX
If the display still doesn't scroll, try disconnecting the power and re-
connecting it again. If still no success, do the following:
With PCCU32, connect to the unit and establish communications such as
Connect To Totalflow, Entry Mode, etc. Go into Terminal Mode and type
"0.0.0=COLD" (Do not enter quotes). The unit should go through a Cold
Start procedure and then begin scrolling. If this does not succeed, call
the number on the back of this guide and talk to a customer service
representative.
22
XFC6200EX Prom
2101715-001
(COPYRIGHT)
or
COLD FLASH
Flash 2101715-001
6200EX Flash
2101715-001
(COPYRIGHT)
Advertisement
