modway EEI-2671 Quick Start Manual

EEI–2671

CHAIR

Thank you for purchasing the MODWAY Chair！

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe and

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that have been provided.

6.Please keep all fitting out of reach of children.

Chair Body

Customer Service 908-368-1025︱www.modwayfurniture.com

Front Leg

Bolt M6x16mm

Spring Washer M6

Flat Washer M6

Allen Wrench M4

x 12

x 1

Back Leg

Page 1 of 2

Table of Contents

Need help?

Do you have a question about the EEI-2671 and is the answer not in the manual?

Page 1 EEI–2671 CHAIR Thank you for purchasing the MODWAY Chair！ Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2.Owing to the size and weight of the chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI–2671 CHAIR STEP 1: Please put Chair Body (1) upside down on a carpeted or padded area. Positon 1 piece of Back Leg (3) to the bottom of Chair Body (1). Insert 3 pieces of Bolt (A) with 3 pieces of Spring Washer (B) and 3 pieces of Flat Washer (C) into the holes on bottom of Chair Body (1) through the holes on Back Legs (3) as shown.