Connecting the AC power cord ________________
Plug the fax into a 200-240 volt AC 50/60 Hz outlet.
1
Plug the power cord connector into the
rear of the fax.
When you plug in the fax for the first time, you need to select the correct language for the LCD display and
reports, and the country* of use.
Setting the language and country
K K
1
Plug in the fax.
After a few seconds, the LCD changes to this display.
2
Use [u] or [d] to select the preferred language for
the LCD display and reports.
Press [Set].
Wait a second for COUNTRY SELECT*
to appear.
Press [Set].
3
Use [u] or [d] to select the country where you are
using the fax*.
Press [Set].
Registration ends and the fax enters standby mode.
* This setting is only available for some countries.
2
Plug the other end of the power cord into
a properly grounded AC power outlet.
There is no power switch on the fax. The
power is on as long as the fax is plugged in.
Set
Set
Set
Making connections
u
d
u
d
1 sec.
1-7
1