Table of Contents
Advertisement
Introduction
Thank you for purchasing the H.R.UV-C SPA pool sanitising system, manufactured to the highest
standards in England.
To ensure years of trouble-free service, please read and follow these instructions for proper installation,
maintenance and use. Incorrect installation will affect your warranty.
Please retain this manual for future reference.
1. IMPORTANT SAFETY INSTRUCTIONS
WARNINGS:
• Read the maintenance instructions before opening the appliance.
• Do not operate the ultraviolet-C emitter when it is removed from the appliance enclosure.
• Unintended use of the appliance or damage to the housing may result in the escape of
dangerous ultraviolet-C radiation. ultraviolet-C radiation may, even in little doses, cause
harm to the eyes and skin.
• This unit must be earthed.
• Power must be supplied through a Residual Current Device (RCD) with a rated residual
operating current not exceeding 30mA
• Do not run this unit dry
• Do not cover this unit
• The unit must not be submerged in water
• Carefully examine the unit after installation. It should not be powered on if there is water
on any parts not intended to be wet
• If the unit shows any sign of water leakage immediately disconnect power supply
• If the quartz sleeve is cracked, replace it immediately
• To avoid injuries young children should never be allowed near UV sanitizer
• Failure to disconnect the power from the UV sterilizer and pump before servicing or
maintenance could result in personal injury or property damage.
2. PRODUCT OVERVIEW
The
H.R.UV-C SPA
either an analogue lamp life indicator and reset switch, or digital lamp life countdown with intelligent
dosing pump.
is available in 30W single tube format, supplied complete with flow switch and
3
Advertisement
Table of Contents
Need help?
Do you have a question about the CLASSIC H.R. UV-C SPA and is the answer not in the manual?