Related Manuals for KC STORE FIXTURES 16525
Summary of Contents for KC STORE FIXTURES 16525
- Page 1 FRAMELESS GLASS CORNER UNIT #16525 www.kc-store-fixtures.com 7400 E. 12th Street, Kansas City, MO 64126 • 1-800-862-0899 PAGE 1 OF 8...
-
Page 2: Parts List
FRAMELESS GLASS CORNER UNIT #16525 Parts List: "M" bracket "L" bracket Door hinges Door stop & screw Door lock Qty. 3 Qty. 12 Qty. 2 Qty. 1 Qty. 1 Plastic tube Nuts Plastic sleeves 7/8" Bolt 1/2" Bolt Screws for lock Wood screws Qty. - Page 3 FRAMELESS GLASS CORNER UNIT #16525 Place wood base on a level surface. STEP 1 The base is pre-grooved for back and side panels. Set the two back panels (Q) into the grooves at a 90 degree angle. Attach the two panels using two "L" brackets (B) along the vertical corner.
- Page 4 FRAMELESS GLASS CORNER UNIT #16525 STEP 3 Insert side panels (P) into grooves on wood base. Connect corners where side panel meets back glass panels using four "L" brackets. Place "L" bracket (B) on the inside of glass panels and align with holes.
- Page 5 FRAMELESS GLASS CORNER UNIT #16525 STEP 5 Along the front edge of each side panel are two pre-drilled holes for shelving. In each hole, insert a 7/8" bolt (I) and plastic sleeve (H) through the hole from the outside. Once through the hole, add a nut (G) and tighten. Slide a plastic tube (F) over the end of the bolt (Fig.
- Page 6 FRAMELESS GLASS CORNER UNIT #16525 STEP 7 Attach "M" bracket (A) on the inside of each corner at the top of the glass panels. Insert a 1/2" bolt (J) into plastic sleeve (H) from the outside of the glass, slide both through pre-drilled holes and screw into the bracket on the insde.
- Page 7 FRAMELESS GLASS CORNER UNIT #16525 STEP 9 Attach bottom door hinge (C) to lower, right corner of door panel (R). Make sure screws are on the inside of the door and post is pointing down. Place cup in hole on wood base then in- sert post.
- Page 8 FRAMELESS GLASS CORNER UNIT #16525 STEP 11 Slide door lock (E) onto bottom door edge. Align the tab under the lock with the pre-cut slot in the wood base. Ensure lock slides smoothly up and down with key prior to tightening screws.