Care And Maintenance; Car And Maintenance - Daitsu APD12-AN User Manual

Remove the air fi lter out
from the grille
Band
Power cord
25

CARE AND MAINTENANCE

Air fi lter
(slide out)
Fig. 26
Remove three
screws and take
the air intake
grille down
Fig. 27
Fig. 28
Fig. 29
Fig. 30
IMPORTANT
1) Be sure to unplug the unit before cleaning or servicing.
2) Do not use gasoline, thinner or other chemicals to clean
the unit.
3) Do not wash the unit directly under a tap or using a hose.
It may cause electrical danger.
4) If the power cord is damaged, it should be repaired by
manufacture or its agency.
1. Air fi lter:
- Clean the air fi lter at least once every two weeks to
prevent inferior fan operation because of dust.
- Removal
This unit has two fi lter. Grasp the upper fi lter tab (Fig.26),
pull the fi lter out then up . Remove the lower fi lter by
loosening the screws, taking down the air inlet grille, then
removing the air fi lter as shown in Fig.27 & 28.
- Cleaning
Wash the air fi lter by immersing it gently in warm water
(about 40ºC/104ºF) with a neutral detergent. Rinse the
fi lter and dry it in a shady place.
- Mounting
Insert the upper air fi lter from upward after cleaning,
attach the lower air fi lter to the air inlet grille, then install
the grille by using the screws. Make sure the screws are
securely fastened.
2. Unit enclosure:
- Use a lint-free cloth soaked with neutral detergent to clean
the unit enclosure. Finished by a dry clean cloth.
3. Unit idle for a long time:
- Remove the rubber plug at the back of the unit and
attach a hose to drain outlet. Place the open end of the
hose directly over the drain area in your basement fl oor
(See Fig.23-24).
- Remove the plug from the bottom drain outlet, all the
water in the bottom tray would drain out (See Fig.25).
- Keep the appliance running on FAN mode for half a day
in a warm room to dry the appliance inside and prevent
mold forming.
- Stop the appliance and unplug it, wrapped the cord and
bundle it with the tape (Fig.29). Remove the batteries
from the remote controller.
- Clean the air fi lter and reinstall it.
- Unscrew the exhaust hose to the right or left and pull out
for uninstallation (Fig.30), keep it safety or place behind
the air intake grille, and cover the window (wall) hole with
the adaptor cap.