Basic Setup & Operation - Hitachi L42S601 Service Manual

How to set up your new Hitachi LCD Television
AC CORD AND POWER SWIVEL CABLE INSTALLATION INSTRUCTION
The AC cord and power swivel cable provided with your new LCD Flat Panel Television need to be installed correctly
to avoid their disconnection when rotating the TV on its Table top stand.
Located on the back of the TV are 2 plastic clamps to hold the AC cord and power swivel cable. Please follow
the instructions below.
³
Pass the AC cord through Clamp #1 and connect
it to the TV. Pull on the clamp to tighten the
AC cord to the TV.
·
Connect power swivel cable on one end to the
swivel slot of the LCD Rear Panel.
the other end to the swivel slot of the Table
Top Stand Base.
»
The AC cord, power swivel cable and the signal
cables can all be held together with Clamp #2.
·
Swivel slot on the
LCD back panel.
AC CORD
Connect
³
»
Clamp #2: Use this clamp to hold the AC cord, power
·
Swivel slot on Table Top
Stand Base.
15
Clamp #1 : Pass the AC cord through this clamp ;
then pull the clamp to tighten the AC
cord to the TV.
swivel connector and the signal cables.
DW3G