Basic Operation - Hitachi es50-116cmw User Manual

#
#
#
#
Turning Projector On and Off#
CAUTION#
#When turning power on again, wait until the fan stops (after the STANDBY indicator
changes from blinking to a steady light) The power ON switch will not be active
until then.
#The power switch on the projector must be ON.#
Operational procedure#
1. To turn power on#
Step
1
%Turn on the main power switch on projector.
%The ON indicator on control panel will light orange to show that the
projector is in the standby status.(If the projector is connected to a
system, also turn on system equipment in addition to the projector.)
2 %Press the POWER button on remote or the power button on
control panel to turn the projector on.
%The ON indicator on control panel will change to blinking in green,
and the projector will enter the setup operation to light the lamp of
light source.
%After several seconds, the lamp of light source will light, and the ON
indicator on control panel will change to a steady green light.
#
2. To turn power off
Step
1
%Hold down the POWER button on remote control or the power button on
control panel for approximately one second: The lamp will turn off.
%The ON indicator on control panel will change to blinking in orange, and
the projector will enter the operation to cool the lamp of light source
(cooling after use) .
%After approx. one minute, the cooling fan will stop, and the projector will
enter the standby status for next power on.
2
%Turn off the main power switch on projector.
#$ The ON indicator on control panel will go out.
Caution
Do not turn the main power switch off until the fan stops
completely. Turning the switch off while the fan is in rotation may
damage the lamp.

Basic Operation

Details of operation
Details of operation
!+#
!
Main Power SW
& ON indicator
Power
Button
Power
Button
Main Power SW
& ON indicator