Installation Instructions - Access SLANTBACK Roll-Up Cover Installation Instructions And Owner's Manual

INSTALLATION INSTRUCTIONS:

(NOTE: For additional installation assistance go online to accesscover.com
instruction manual and click on installation video.)
PREPARATION
TOOLS NEEDED:
1 - 1/2" wrench (for rail clamps)
1 - Spring clamp optional
(to hold rails in place while clamping)
NOTE ON BED LINERS: With an under-the-rail drop in bed liner, installation is
possible with minimal trim cutting of bed liner at front corner of box and back by
tailgate to allow side rail to install properly. Considerable trim cutting is required
with an over-the-rail drop in bed liner.
1: INSTALLING COVER SIDE RAILS
NOTE: Some installs require drilling/bolting. Those kits will contain special side
rail instructions. Follow those instructions for rail attachment in conjunction with
instructions in this owner's manual.
Shape of rail may vary
At front set top
of rail flush with
top of box
Top of rail flush with top
side of box at front
Nylon
strike to
rear
This part of
the rail should
be near level
Unpack cover components.
Clean truck box if dirty.
COMPONENTS:
1 driver side rail
1 passenger side rail
1 element seal kit
6 clamps (long box kits 8 clamps)
1 left and 1 right tension adjuster with nuts & bolts
1 pre-rolled up cover assembly
1 - Tape measure or ruler
2 - 9/16" wrenches
Protective eyewear
A. Position side rail with weather
strip against inside lip of box.
Push rail forward until it touches
front of box. End of rail with
strike goes to rear.
B. At front, adjust top of rail
flush with top of box and
hold it there with assistance
of another person or with a
spring clamp.
2
1 - Scissor