1. Manuals
  2. Brands
  3. Access Manuals
  4. Automobile Accessories
  5. LORADO
  6. Installation instructions and owner's manual

Access LORADO Installation Instructions And Owner's Manual

Roll-up cover
Hide thumbs Also See for LORADO:
Table of Contents

Advertisement

Quick Links

Download this manual
Thank you for purchasing ACCESS
manufactured this cover with pride using superior quality materials and
workmanship. With proper care, your cover will provide years of service and
enjoyment.
NOTICE TO INSTALLER: It is recommended instructions are read before
installation, even if familiar with cover. Improvements may be made without
prior notice. Always handle cover and components with care. If you have any
problems or questions, have serial number ready and call customer service.
When done, this owner's manual must be given to the consumer.
NOTICE TO CONSUMER: Before using cover, read operating, maintenance,
and safety sections and save owner's manual for future reference.
DATE PURCHASED:
WHERE PURCHASED:
SERIAL NUMBER:
Call Us First!
HELP LINE
HELP LINE
STOP
®
FOR YOUR RECORDS
(Located on decal under rear bar by tailgate)
1-866-630-8726
Tested. Trusted. Guaranteed.
INSTALLATION INSTRUCTIONS
AND OWNER'S MANUAL
LORADO
Roll-Up Cover. ACI
®
Problems? Questions? Missing or
Damaged Parts? Install Questions?
Customer Service Hours:
8:00am-5:00pm CST, Mon. - Fri.
1
®

Advertisement

Table of Contents
loading

Related Manuals for Access LORADO

Summary of Contents for Access LORADO

  • Page 1 INSTALLATION INSTRUCTIONS AND OWNER’S MANUAL Thank you for purchasing ACCESS LORADO Roll-Up Cover. ACI ® ® ® manufactured this cover with pride using superior quality materials and workmanship. With proper care, your cover will provide years of service and enjoyment.

  • Page 2: Installation Instructions

    INSTALLATION INSTRUCTIONS: NOTE: For additional installation assistance go to LORADO.COM for install video. PREPARATION Unpack cover components. Clean truck box if dirty. COMPONENTS: 1 driver side rail 1 passenger side rail 1 ELEMENT SEAL 6 clamps (long box kits 8 clamps) 1 left and 1 right tension adjuster with nuts &...
  • Page 3 1. INSTALLING COVER SIDE RAILS (Continued) C. Install first clamp as close to front Temporary of bed as possible and use 1/2” spring clamp wrench to tighten. IMPORTANT: To keep rail on truck secure, make sure clamp teeth engage grooves on rail, turn nut finger tight and then use 1st clamp wrench to finish tightening.
  • Page 4 2: APPLY ELEMENT SEAL GASKET NOTE: For best adhesion, air and surface temperature should be above 60 A. At front of box header, clean top surface with alcohol pad (if needed wash first). Save alcohol pad for Clean top of box use in step #3.
  • Page 5 3: APPLY REAR SEAL (Continued) C. Peel paper back, align and adhere seal at end of rail. Rail Edge of Trim excess seal Rear seal D. Edge seal installed. 4. ASSEMBLING TENSION ADJUSTERS TO COVER A. The cover comes pre-rolled in its normal open position for ease of installation.
  • Page 6 5. MOUNTING COVER TO SIDE RAILS A. Set rolled up cover on rails at front of box (behind cab) with front bar facing up. Roll cover bar onto front of rails and fold/tuck vinyl flap under. Now, bar will face down. Let straps hang to inside of box.
  • Page 7 6. INITIAL OPERATION AND ADJUSTMENTS A. Unroll cover and place rear bar into strikes on side rails. Press down on bar to close (20-30 lbs pressure). The cover fabric may be tight. Over time, under tension, it will conform to its hardware and loosen slightly. If bar is too hard to push down, adjust tensioners equally as needed to close.
  • Page 8 OPERATING ROLL-UP COVER Note: view opening and closing demonstration video on lorado.com TO CLOSE Release retainer straps at Position roll-up bar against Alongside of box, seal cover front and using both hands, roll strikes. Push down on bar edges with hook and loop seal- cover to rear of box.

  • Page 9: Parts Diagram

    STRAP ADJUSTMENT To tighten storage strap, pull back on To take out slack in loop, slide slip top layer of strap loop until strap is snug. bracket down. PARTS DIAGRAM Front bar Support Premium bows storage straps Rear bar Front ELEMENT SEAL XT-DIAL...

  • Page 10: Troubleshooting

    TROUBLESHOOTING PROBLEM SOLUTION Turn both tension adjusters counter clockwise to Cover too loose move front bar forward. (Refer to Step 6C, see arrows next to adjuster) Turn both tension adjusters clockwise to move front Cover too tight bar back. (Refer to Step 6C, see arrows next to adjuster) Rails set too high (Refer to Step 6B) Gap between roll-up bar and...

  • Page 11: Inspection And Maintenance

    INSPECTION AND MAINTENANCE • Inspection and much of the maintenance can be done by the operator. It may be necessary to review the installation and operating instructions. • Periodically inspect the cover assembly and the condition of all parts. Check for loose bolts and parts, tighten if needed. Test the operation to ensure that the parts are functioning properly and that the cover is in top operational condition.

  • Page 12: Manufacturer's Limited Warranty

    Service at 866-630-8726. Agri-Cover, Inc. Customer Service Dept PO Box 508 | 3000 Hwy 281 SE Jamestown, ND 58402 Phone: 866-630-8726 ACCESS - A Division of Agri-Cover, Inc. ACCESS and LORADO are registered United States trademarks of AGRI-COVER, INC. ® ®...

Table of Contents