Table of Contents
Advertisement
2: APPLY ELEMENT SEAL
CLEAN
TOP OF
BOX
HEADER
ELEMENT
SEAL
ALIGN SEAL
AGAINST
FRONT OF
RAIL AND
INSIDE EDGE
OF BOX
STARTING
HERE
NOTE: For additional protection–locate and seal miscellaneous factory
holes, crevices, stake pockets, etc. that may be on box (sealant not included).
3: ASSEMBLING TENSION ADJUSTERS TO COVER
Nut
INSIDE FRONT
OF BOX
SIDE RAIL
"L" Left
XT Dial
A. At front of box header, clean top
surface with alcohol pad (if needed
wash first).
B. Peel paper back, align and adhere
Element Seal™ at one corner across box
to opposite corner and cut to length.
A. The cover comes pre-rolled to
its normal open position for ease
of installation. Set pre-rolled cover
on tailgate with front bar facing up
as shown. Align XT Dial Tension
Adjuster (marked "L") on driver side of
cover– positioned as shown in photo.
B. Turn 1-¼" bolt with flat washer onto
nut in bar. Leave loose for now. See
photo. Repeat for XT Dial ("R") on
passenger side of cover, and leave that
bolt loose also.
4
Advertisement
Table of Contents
