Table of Contents
Advertisement
4: MOUNTING COVER TO SIDE RAILS
Center front bar between
rails until space is equal
at both ends
Tab goes
under–
then
tighten
bolt
A. Set rolled up cover on rails at front of
box (behind cab) with bar facing up. Roll
cover bar onto front of rails and fold/
tuck vinyl flap under. Now bar will face
down. Let straps hang to inside of box.
Push cover bar forward until it sets flat on
front of side rails and overhangs them.
B. Slide left tension adjuster over until
it engages under side rail. (See photo in
Step 4 E for tension adjuster tab under
side rail.) Push bar back and forth to
line up holes-do not turn dial wheel.
Insert bolt from top, flat washer and
nut from bottom.
C. Hold bolt at top and tighten nut un-
der side rail. Repeat procedure for right
hand tension adjuster.
D. Center the front bar between the
two side rails.
NOTE: Before tightening, make sure vinyl
weather flap is still tucked under front bar.
E. Then tighten bolt (left loose
earlier) under front bar on
each tension adjuster.
5
Advertisement
Table of Contents
