Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS:
NOTE: For additional installation assistance go to LORADO.COM for install video.
PREPARATION
TOOLS NEEDED:
2 - 1/2" wrenches
1 - Spring clamp optional
(to hold rails in place while clamping)
NOTE ON BED LINERS: With an under-the-rail drop-in bed liner, installation is
possible with minimal trim/cutting of bed liner at front corner of box and back by
tailgate to allow side rail to install properly. Considerable trim/cutting is required
with an over-the-rail drop-in bed liner.
1. INSTALLING COVER SIDE RAILS
NOTE: Some installs require drilling/bolting. Those kits will contain special side
rail instructions. Follow those instructions for rail attachment in conjunction with
instructions in this owner's manual.
Top of rail should be
flush with top side
of box at front
This edge of rail flush
with top on side of
box at front
Unpack cover components.
Clean truck box if dirty.
COMPONENTS:
1 driver side rail
1 passenger side rail
1 ELEMENT SEAL
6 clamps (long box kits 8 clamps)
1 left and 1 right tension adjuster with nuts & bolts
1 pre-rolled up cover assembly
Nylon
strike
to rear
This surface of
the rail should
be level
2
kit
TM
1 - Tape measure or ruler
Protective eyewear
1 - Scissor
A. Position side rail with weather strip
against inside lip of box. Push rail
forward until it touches front of
box. End of rail with strike goes to
rear.
B. At front, adjust top of rail flush with
top of box and hold it there with as-
sistance of another person or with a
spring clamp.
Advertisement
Table of Contents
