Table of Contents
Advertisement
5: INITIAL OPERATION AND ADJUSTMENTS
To loosen Cover
Turn Clockwise
To Tighten Cover
Turn Counter
Clockwise
A.Unroll cover and place rear bar into
strikes on side rails. Press down on bar to
close (20-30 pounds pressure). The cover
fabric may be tight. Over time under ten-
sion it will conform to its hardware and
loosen slightly. If bar is too hard to push
down, adjust tensioners equally as needed
to close.
B. Close tailgate slowly - top of tailgate
should fit snug under cover bar. If it is too
tight - raise rails by loosening rear clamps
adjust rail up and tighten clamps. If too
loose adjust rails lower.
C. Check cover tension by releasing
autolatch and open and close rear bar
several times. It should snap down when
closing. Cover fabric should sound drum
like when tapped on. If adjustment is
needed, roll cover open and to loosen
turn XT-Dial Clockwise. To tighten
turn XT-Dial Counter Clockwise.
Always turn Dials in Equal
amounts. See photo at left.
D. When done, always seal both
sides of cover with hook and loop
system. For detailed operating
instructions see Page 7.
TIP: Reasons to keep cover drum tight:
1) Lasts longer
2) Less noise
3) Looks nicer
6
Advertisement
Table of Contents
