Assembly - Weider 230 User Manual

ASSEMBLY

Make Assembly Easier
This manual is designed to ensure that the
weight bench can be assembled successfully
by anyone. Most people find that by setting
aside plenty of time, assembly will go smoothly.
Before beginning assembly, carefully read the
following information and instructions:
• Assembly requires two persons.
• Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
1.
To make assembly easier, make sure that
you understand the information in the box
above.
Locate the Stabilizer (4) without the warning decal.
Attach the Stabilizer to the Front Leg (2) with two
M10 x 63mm Carriage Bolts (18) and two M10
Nylon Locknuts (19). Do not tighten the Nylon
Locknuts yet.
2. Attach the Frame (1) to the Front Leg (2) with two
M10 x 63mm Bolts (16), two M10 Large Washers
(27), and two M10 Nylon Locknuts (19). Do not
tighten the Nylon Locknuts yet.
All manuals and user guides at all-guides.com
6
• Tighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• For help identifying small parts, see the PART
IDENTIFICATION CHART on page 5.
The included grease and the following tools (not
included) may be required for assembly:
• Two adjustable wrenches
• One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly will be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
1
2
19
4
2
1
19
19
18
27
16
27
2