Worx WG324E Manual page 16

Adaptive guide
bar type
Charging time
Extension pole
length
Maximum
cutting height
Extension pole
weight
Machine weight
(chain & bar
included)
** Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
NOISE INFORMATION
A weighted sound pressure
K
pA
16
A weighted sound power
K
pA
Wear ear protection.
VIBRATION INFORMATION
Vibration total values (triax vector sum) determined
according to EN 62841:
Vibration emission value:
Uncertainty
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise emissions
during actual use of the power tool can differ from
the declared value depending on the ways in which the
tool is used especially what kind of workpiece is
processed dependant on the following examples and
Cordless Pruning Saw
WA0151
1 hr 1 hr
/ 125 cm
/ 275 cm
/ 1.1 kg
1.75 kg 2.8 kg 1.38 kg
L = 79 dB(A)
pA
L = 88.11 dB(A)
wA
a < 2.5 m/s 2
h
K = 1.5 m/s2
other variations on how the tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well maintained.
/
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
/ The tightness of the grip on the handles and if any anti
vibration and noise accessories are used.
And the tool is being used as intended by its design
/
and these instructions.
This tool may cause hand-arm vibration
/
syndrome if its use is not adequately managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimise your vibration and noise exposure
risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
3 dB(A)
vibration and noise accessories.
Plan your work schedule to spread any high vibration
tool use across a number of days.
3 dB(A)
ACCESSORIES
WG324E WG324E.1 WG324E.2 WG324E.9
Chain
(WA0142)
Guide bar
(WA0151)
Lubrication
oil
Bar and
Chain
Sheath/
Scabbard
Charger
(WA3880)
Battery
(WA3551)
Exten-
sion pole
(WA4301)
We recommend that you purchase your accessories
1 1 1
1 1 1
1 1 1
1 1 1
1 1 1
1 1 2
/ 1 /
1
1
1
1
/
/
/
EN