Control Panel - NOMA 043-6164-2 Instruction Manual

1. Remove the plastic nut by turning it counter-clockwise.
2. Place the rear guard on the head unit; make sure the handle is upward.
3. Screw on the plastic nut (clockwise) securing the fan guard on the head
unit (see Fig. 5).
4. Install the fan blade onto the motor shaft. Make sure the fan blade slot fits into the
retaining pin of the motor shaft.
5. Attach the spinner to the motor shaft by turning it counter-clockwise. to secure the
fan blade (see Fig. 6).
6. Remove the small screw from the rear or front guard. Mount the front guard and join
both guards together using the clips. Make sure the screw hole on both guards are align
together using a screwdriver (see Fig. 7).
Spinner
Tight
Loose
Plastic nut
Fig. 5
I. CONTROL PANEL
On the control panel, there are two buttons and six
indicator lights (see Fig. 8).
1. " " SPEED ON/OFF BUTTON
This button is for switching fan and setting speed.
Press it repeatedly to change speeds. ON (LOW),
MEDIUM, HIGH, OFF. ON (LOW).
2. " " TIMER BUTTON
Press this button once to set the timer for one (1) hour. Press it a second
time for two (2) hours. Press it a third time for four (4) hours. Don't press
this button if you want the fan to run continuously.
If the fan isn't in timer mode, the timer LEDs won't be lit.
Spinner Tight
Slot
Retaining
Pin
Blade
Fig. 6
Clip
Fig. 7
Fig. 8
5