Yamaha WR125R 2009 Service Manual page 97

EWA13040
WARNING
• If coolant splashes in your eyes, thorough-
ly wash them with water and consult a doc-
tor.
• If coolant splashes on your clothes, quickly
wash it away with water and then with soap
and water.
• If coolant is swallowed, induce vomiting
and get immediate medical attention.
ECA22B1005
NOTICE
• Adding water instead of coolant lowers the
antifreeze content of the coolant. If water is
used instead of coolant, check and, if nec-
essary, correct the antifreeze concentra-
tion of the coolant.
• Use only distilled water. However, if dis-
tilled water is not available, soft water may
be used.
• If coolant comes into contact with painted
surfaces, immediately wash them with wa-
ter.
• Do not mix different types of antifreeze.
10.Install:
• Radiator cap "1"
• Radiator cap lock bolt "2"
Radiator cap lock bolt
1 Nm (0.1 m·kgf, 0.7 ft·lbf)
TIP
Install the radiator cap so that the lock bolt faces
forward as shown in the illustration.
2
11.Fill:
• Coolant reservoir
(with the recommended coolant to the maxi-
mum level mark "a")
1
3-16
12.Install:
• Coolant reservoir cap
13.Start the engine, warm it up for several min-
utes, and then turn it off.
14.Check:
• Coolant level
Refer to "CHECKING THE COOLANT LEV-
EL" on page 3-14.
TIP
Before checking the coolant level, wait a few
minutes until the coolant has settled.
15.Install:
• Left rear side cover
• Seat
Refer to "GENERAL CHASSIS" on page 4-1.
ENGINE
a