Yamaha WR125R 2009 Service Manual page 61

1. Clutch cable
2. Meter assembly
3. Front brake hose
4. Throttle cable
5. Front brake light switch lead
6. Right handlebar switch lead
7. Left handlebar switch lead
8. Clutch switch lead
9. Speed sensor lead
10. Front left turn signal lead
11. Main switch
12. Headlight coupler
13. Wire harness
14. Auxiliary light coupler
15. Front right turn signal lead
A. Fasten the front brake light switch lead with the
plastic band at the bend in the handlebar.
B. Fasten the right handlebar switch lead and front
brake light switch lead with the plastic band at the
bend in the handlebar.
C. Route the right handlebar switch lead, left
handlebar switch lead, clutch switch lead, front
brake light switch lead, and throttle cable between
the meter assembly and the upper bracket.
D. Fasten the left handlebar switch lead and clutch
switch lead with the plastic bands at the bend in
the handlebar.
E. Fasten the wire harness at the white tape with a
plastic locking tie.
F. Route the wire harness to the rear of the front
brake light switch lead, left handlebar switch lead,
and right handlebar switch lead.
G. Fasten the left handlebar switch lead, right
handlebar switch lead, clutch switch lead, and front
brake light switch lead at the white tape on each
lead with a plastic locking tie.
H. Fasten the left handlebar switch lead, right
handlebar switch lead, clutch switch lead, and front
brake light switch lead to the upper bracket stay
with a plastic locking tie.
2-36
CABLE ROUTING