Advertisement
c）調整好後裝回橡膠孔塞。（注：電機兩
平面裝的越平越好，如果兩平面超過 1.5mm
的情況下，電機會比正常安裝的發熱量大和
力矩減小現象。）
（5）裝手輪和外殼：
a) 用手轉動轉子，使機針停在最天秤高位，
縫紉機手輪如圖 B
b) 如安裝圖所示將圖⑧手輪裝入並用圖⑨螺
釘鎖緊 ,（注：停車針位和手輪與電機間隙
如圖 A、B、C）
c) 將如安裝圖所示將圖⑩塑膠外殼裝入並用
圖 的螺釘鎖緊
圖 A (Pic.A)
（6）檢查：手轉動手輪無卡擦現象，縫紉機
也無加重。
P7
c）Adjusted to fit back rubber hole stopper.
(Notes: The distance between two flat as small
as possible, if more than 1.5mm, motor will be
calorific value more and torque decreases.)
（5）Install Hand wheel and the cover:
a)Use hand to turn the rotor, let the needle
stop in thescales highest position
b)According to the above install picture to
install the Hand wheel(picture ⑧ ), use the
screw(picture ⑨ )to fix.(Attention: the needle
stop position and the clearance of Hand wheel
and the motor is as following picture A、B、C)
c)According to the above install picture, install
the cover(picture ⑩ ), and use the picture
screw to fix.
圖 B (Pic.B)
（6）Check: Hand wheel hand wheel without
card wiping phenomenon, Sewing machine
weight does not increase.
圖 C (Pic.C)
Advertisement
