Kohler K-1098 Installation Manual page 8

Hot
Thread
Protector
4. Install the Yoke - Ceiling Installations
IMPORTANT! Perform these steps for ceiling installations only.
The faucet fitting is factory assembled specifically for hot and
cold water supplies from the floor.
If installing the faucet for ceiling supplies, turn the yoke over so
the supplies connect from the top.
Remove the aspirator with a 3/8" hex wrench.
For the K-1098, reinstall the aspirator at the top of the yoke. Do
not overtighten. For the K-1099, discard the aspirator.
Reversing the yoke for ceiling supplies reverses the direction the
lever handles close.
For proper operation, reverse the ceramic valves.
Open the valve before removing it.
Tighten the valves securely.
If you are installing K-1099, proceed to the next section.
114542-2-BC
Ceiling
Supplies
Aspirator
Cold
Valve Unit
8 Kohler Co.