Troubleshooting; Sound And Audio Volume; Bluetooth ® Device Connection; Phone Calls - Panasonic Technics EAH-AZ60 Owner's Manual

Troubleshooting

Before requesting service, make the following checks. If you are in doubt about some of the check points, or if
the remedies indicated in the chart do not solve the problem, refer to "Customer Services Directory"* if you
reside in the U.S.A., or refer to "CONTACT INFORMATION"* if you reside in Canada, or consult your dealer for
instructions.
* Refer to "Limited Warranty".

Sound and audio volume

No sound.
• Make sure that the earphones and the Bluetooth
• Check if music is playing on the Bluetooth
• Make sure that the earphones are turned on and the volume is not set too low.
• Pair and connect the Bluetooth
• Check if the Bluetooth
( l 23). Also refer to the operating manual for the Bluetooth
Low volume.
• Also raise the volume on the Bluetooth
• Make sure there is no earwax, foreign matter, etc., attached to the earpieces of the earphones.
Remove the earpieces from the main unit (earphones) and refer to "Earphones/Earpieces" (
Sound from the device is cut off. / Too much noise. / Sound quality is bad.
• Sound may be disrupted if signals are blocked. Do not fully cover the earphones with the palm of your hand, etc.
• The device may be out of the 10 m (33 ft) communication range. Move the device closer to the earphones.
• Remove any obstacle between the earphones and the device.
• Switch off any wireless LAN device when not in use.
®
Bluetooth device connection
The device cannot be connected.
• You can pair a maximum of 10 Bluetooth
has been exceeded, previous devices are overwritten. To use overwritten devices again, do the pairing again.
• Delete the registration information for this unit from the Bluetooth
l
again. ( 21)

Phone Calls

The voice of the person on the other end of the call is small.
• Also raise the volume on the Bluetooth
Cannot make a phone call.
• Check if the Bluetooth
l
music" ( 23) and "Making a phone call" (
phone.
• Check the audio settings on the Bluetooth
with this unit, change the setting. (
The other party finds it hard to hear your voice during a call.
• The earphones detect your voice with voice activity detection microphones to enable the other party to hear it. Your
voice cannot be detected if the earpieces are not fitted snugly into your ears. Replace with earpieces that fit snugly
into your ears. ( l 12)
®
device.
®
device and the earphones again. (
®
compatible device supports "A2DP" profile. For details on profiles, see "Listening to music"
®
device, not just on the earphones.
®
devices with the earphones. When you pair a device after the maximum
®
device, not just on the earphones.
®
compatible device supports "HSP" or "HFP" profile. For details on profiles, see "Listening to
l
®
compatible telephone, and if the setting does not allow communication
l
21)
Other
®
device are connected correctly. (
l
®
compatible device.
®
menu, etc., of the Bluetooth
24). Also refer to the operating manual for the Bluetooth
31
l
21)
21)
l
5) to clean them.
®
device, then pair
®
enabled