Other; Restoring To The Factory Settings; Troubleshooting - Panasonic RZ-B110W Owner's Manual

Digital wireless stereo earphones
Hide thumbs Also See for RZ-B110W:
Table of Contents

Advertisement

Restoring to the factory settings

When you want to delete all pairing device information, etc. in the earphones, you can restore the
earphones to the factory settings (original settings upon purchase).
Important:
R Charge the earphones before restoring the earphones to their factory settings.
RZ-B310W:
1
Open the charging cradle lid.
R Wait until the status indicator goes off.
2
While the earphones are in the charging cradle, press the reset button rapidly 5 times.
R The status indicator flashes in orange 3 times. When the reset is finished, the status
indicator goes off.
RZ-B110W:
1
Take both earphones (L and R) out of the charging cradle.
2
Touch the touch sensor (L or R) rapidly 6 times in disconnected state.
R When the reset is finished, the unit beeps.
Note:
R To re-pair the earphones with a Bluetooth
name: RZ-B310W or RZ-B110W) on the device, then pair the earphones with the Bluetooth
device again.

Troubleshooting

Before requesting service, make the following checks. If you are in doubt about some of the
check points, or if the remedies indicated do not solve the problem, consult your dealer for
instructions.
Does not connect with the Bluetooth
R Delete the registration information for this unit from the Bluetooth
®
Bluetooth
device, then pair again (page 9).
R If you want to connect to the other device, you have to disconnect the connected device.
R You can pair a maximum of 4 Bluetooth
maximum of 10 Bluetooth
after the maximum has been exceeded, previous devices are overwritten. To use overwritten
devices again, do the pairing again.
The left and right batteries deplete at different rates.
R There may be some difference between left and right due to signal and usage condition.
Cannot charge the unit.
R Make sure to charge in a room temperature between 10 °C (50 °F) and 35 °C (95 °F).
RZ-B310W: In this case, the earphones are not charging when the status indicator continues
to flash.
®
device, delete the registered information (device
®
device.
®
devices with the RZ-B310W earphones and a
®
devices with the RZ-B110W earphones. When you pair a device
®
menu, etc., of the

Other

®
15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rz-b310wRz-b110wdg-kRz-b310wdg-k

Table of Contents