Electrical Supply Preparation; Water Supply Installation - LG LDF9932 Series Training Manual

TRAINING MANUAL

ELECTRICAL SUPPLY PREPARATION

The dishwasher can be hardwired if necessary and if permitted by local code. We
recommend the use of a dishwasher installation kit, available at most hardware and home
supply stored. This kit includes a cordset, a flexible water supply line, and the elbow
connector necessary to connect it. Using a cordset requires an electric outlet under the
sink accessible when the dishwasher is installed. The cordset makes it easier to
disconnect the dishwasher from power while working on it and makes removal and
replacement easier. As stated earlier, installation requires a properly fused and grounded
dedicated circuit.
WATER SUPPLY PREPARATION
The dishwasher may be connected to either hot or cold water. If the hot water can not
maintained below 149° F, the dishwasher must be connected to the cold water supply.
Lay out the water supply line as indicated on page 6 of this training manual. Use sealing
tape or joint compound to avoid leaks.
INSTALLATION
LDF9932XX
After sliding the dishwasher into position,
adjust the leveling legs.
The left rear leg can be raised or lowered
by turning the adjusting screw with a
Phillips screwdriver. (This is slightly easier
when the dishwasher is tipped forward
very slightly, just enough to take the
weight off the rear leg.
The right rear leg is adjusted in the same
manner.
(See exploded view, next page.)
Page 7
LDF9932XX
DISHWASHER