TRAINING MANUAL
FLOAT SWITCH ASSEMBLY
BASE ASSEMBLY
STEAM GENERATOR
LDF9932XX
The float switches can be removed without
removing the assembly from the
dishwasher. This allows replacement of the
electrical switches and / or the part that
holds the switches.
Press the tabs with a driver and lift the top
of the switch assembly away from the
body.
Remove the screws (8) that secure the
base to the dishwasher.
All the wiring connections and hoses
should have been removed already.
Remember, the hoses stay with the sump at
this point.
The steam generator is mounted on the
left side of the dishwasher.
Disconnect the wiring to the thermistor,
the low water sensor, and the high water
sensor.
Remove the hose clamps. There are two;
one for the input and one to deliver steam
to the tub.
Remove the screws (2) and lift the steam
generator out of the base.
Be careful, in case the water in it is HOT!
Page 18
LDF9932XX
DISHWASHER