Installation - LG LDF9932 Series Training Manual

TRAINING MANUAL
Installation is covered briefly for the servicer who may need to uninstall and reinstall the
dishwasher for repairs. For new installations, please refer to the installation guide that
was supplied with the dishwasher.
• We recommend a location as close to the sink as possible (but not directly under
it) for easy connection to water and drain lines.
• The installation must be within 10' (3 m) of the sink for proper drainage.
• If the dishwasher is installed in a corner (next to an adjacent wall), there must be
2" (50 mm) clearance.
• The floor under the dishwasher should be at the same level as the rest of the
room so the dishwasher can slide in and out easily for service.
LDF9932XX

INSTALLATION

Drill a 1½" hole on either side to allow for
the drain hose, water supply hose, and
electrical cable. The opening must be in an
area within 4" (100 mm) of the back wall
and 4" (100 mm) of the floor.
If there is a floor in the cabinet under the
sink, it will be necessary to cut through it
to connect the water, drain, and electrical
cable under the sink.
The dishwasher must be supplied with
120 V , 60 Hz, 1Ø current as indicated
AC
on the rating plate and connected to a
properly fused and grounded dedicated
20-amp circuit.
The wire or water supply can be fed from
either side, or both from the same side,
depending upon source location.
They must be run in the channels under the
dishwasher, as shown in the drawing.
Page 6
LDF9932XX
DISHWASHER