Quick Start - UCL SWIFT TEK-3 Training Manual

NORTH AMERICA

QUICK START

GUIDE
Connector Adapter
1
INTRODUCTION
The LSMM dual LED source is a multimode test LED used for verifying the proper function of fiber optic
networks. This document will serve as an overview of the major features and functions of the device and will
offer tips for troubleshooting common issues in optical networks.
FEATURES
CONNECTOR ADAPTER
1
(Interchangeable)
WAVELENGTH INDICATOR
2
LOW BATTERY INDICATOR
3
4 POWER BUTTON
5
2 KHZ BUTTON
6
WAVELENGTH BUTTON
7
EXTERNAL POWER PORT
LSMM
Low Battery
2kHz Button
Indicator
3
4
Power Button
2
Wavelength Indicator
The LSMM comes with an SC screw-on adapter. Additional adapters are
available from SWIFT.
This unit offers 850nm and 1300nm wavelengths. When the LSMM is
turned on, the red light indicates which wavelength is selected. The red
light will blink to indicate when the 2kHz modulation is turned ON.
A red indicator light appears when the CR2 battery power is low.
Replace the battery to return to normal operation of the LSMM.
Press this button to turn the LSMM ON and OFF. The unit will turn off
automatically after 15 minutes. To bypass the auto-shutoff, hold the
power button for 5 seconds when turning ON.
Toggles 2kHz modulation of currently-selected wavelength output. LED
flashes at 2000 times per second to provide a recognizable signal to a
companion power meter. Output power of the LED is reduced by 3dB
when the modulation is active.
Switches between the 850nm and 1310nm wavelength.
Accepts PSD1 power supply. Power supply is not a battery charger,
just battery bypass.
LED Light Source - MM
Dual 850/1300nm - SC Adapter (interchangeable)
5
6
Change Wavelength
Button
7
External Power
Port