Sony DVP-S725D Operating Instructions Manual page 62

Speaker Set Up
pBALANCE
You can vary the balance of each speaker as follows.
Default adjustments are in the parentheses.
• FRONT (0dB)
Adjust the balance between the front left and right
speakers (-6dB [L] to +6dB [R], 0.5dB steps).
• REAR (0dB)
Adjust the balance between the rear left and right
speakers (-6dB [L] to +6dB [R], 0.5dB steps).
pLEVEL
You can vary the level of each speaker as follows. Default
adjustments are in the parentheses.
• CENTER (0dB)
Adjust the level of the center speaker (-6dB to +6dB,
0.5dB steps).
• REAR (0dB)
Adjust the level of the rear speakers (-6dB to +6dB,
0.5dB steps).
• SUBWOOFER (0dB)
Adjust the level of the subwoofer (-10dB to +6dB, 0.5dB
steps).
pTEST TONE
You can hear the test tone from each speaker in sequence.
• OFF: The test tone is not emitted from speakers.
• ON: During adjustment of "BALANCE" or "LEVEL,"
the test tone is emitted from both speakers
simultaneously.
Note
While you are playing a disc, you cannot hear the test tone.
Execute the test tone after you stop playback.
To adjust the volume of all the speakers at one
time
Use the receiver's (amplifier's) volume control.
To return to the default setting
Select the item, then press CLEAR.
62
Adjusting the speaker volume
1
While you stop playback, select "SPEAKER SETUP"
after pressing SET UP.
2
Select "TEST TONE" and set "TEST TONE" to "ON."
You will hear the test tone from each speaker in
sequence.
3
From your listening position, select "BALANCE" or
"LEVEL" and adjust the value of "BALANCE" and
"LEVEL" using >/..
During this adjustment, the test tone is emitted from
both speakers simultaneously.
4
Select "TEST TONE" and set "TEST TONE" to "OFF"
to turn off the test tone.