Table of Contents
Advertisement
PackshotStart 360
HARDWARE INSTALLATION
TURNTABLE PLATFORM INSTALLATION 1/2:
01
Lift to remove the top away from
the studio.
04
Remove the 2 small white hand
screws from the rear bottom area
of the studio.
02
Lift to remove both side walls..
05
Install the rear bottom diusion
plate, attach 2 small white hand
screws.
Push the rear
Note:
bottom plate toward the back wall
as close as possible, do not over
tighten the 2 small white hand
screws or else the acrylic will break.
03
Use the magnetic side cover and
cover the openings, one on each
side of the turntable base
06
Remove the tape holding the
driving module.
Advertisement
Table of Contents
