Table of Contents
Advertisement
PackshotStart 360
COMPONENT REPLACEMENT
LED LAMP REPLACEMENT 2/2:
07
Remove the glass turntable
platform if necessary in order to
access their respective LED Lamps.
10
Use a Phillips screwdriver or socket
wrench to remove the screw
holding the LED lamps node on
the LED lamp.
08
Disconnect the two wires by
pressing the connector node while
pulling the wire out.
11
Remove and replace with the new
LED lamp.
The wires and
Note:
LED lamps are marked V+ and V-.
Make sure you plug the V+ wire
into the V+ node, and V-wire to
the V- node on the LED lamp.
09
Use needle nose pliers if necessary.
12
Periodically check for
Caution:
and replace any broken LED
crystals in this system. If one LED
crystal fails, it can cause others in
the same set to
malfunction.
Advertisement
Table of Contents
